Checking off the List for the Trip

The list for getting ready. Our time is shorter to launch, we will be leaving first to mid May to traverse Long Island Sound to New York and the Hudson River..
We ordered and now have a new radio with a DSC button (all new marine radios do) for emergencies, GPS and AIS to assist in  collision avoidance.
Dean is working on fabricating an 8ft. wooden mast to hold the radar dome, mast head light, radio antenna and perhaps deck lights.
We have been reading about solar panels and it seems 2 -160 watt panels, will be adequate to charge a battery bank for powering a small refrigerator, lights, laptop computer and fans while at anchor if used moderately. An inverter will be necessary for the laptop and a few other tools we may use.
A wind generator is helpful on days when there is not sufficient sun, and at night if there is sufficient  wind, but is probably not in the budget
 Our chart plotter uses C-Map charts. Dean has also been talking with Jeppesen www.jeppesen.com for a C-MAP for Lakes and Rivers. That combined with our East Coast and Gulf C-MAP will cover our full trip.
To travel outside the US, including Canada we had to obtain an FCC ships station license (includes an MMSI number $220.00, and a restricted radio operators license ($70.00), not cheap but necessary. Many have suggested getting the license through BoatUS or SeaTow. They will get you the restricted radio operator license for free if you are a member, but their license is only good within the US, not good in Canada, Mexico or the Islands.
Ordered some items from Defender Discount Marine Supplies  www.defender.com 
Purchased 2 new House deep cycle batteries from KMart, which is going out of business in our town.

Next, to order our pilot chairs- 2, as one is needed on the passenger side so the commander can see out the pilot house windows on those long cruises up or down rivers and canals.
I would like to order new carpet, we will see as our list is getting expensive with some of the extras that are required.
To fabricate the dinghy davit mounting brackets is $500.
New dock lines- some of ours are original three strand rope from 1980's-old school.

Unless you have a boat already tailored for the Great Loop or cruising, to install what you want and need before your trips, outfitting with these items can get expensive.
In  the next 2 months, getting our cell phones, data, and internet set up for cruising outside US waters.
GPS and paper maps, mapping your trip including expenses- locks, canals, docking,fuel, pump outs.
Stay tuned

Working on the List for the Great Loop

So far we have a list.
Now we are doing the research for pricing and what else is needed for each project; starting to order a few things and starting work on a few projects. Some will be as simple as replacing old with new. Although, old may be 1980's, i.e. original, 2000- newer, but not used very much so perhaps dried and cracked due to non use as in rubber gaskets and some other parts.  Luckily we have a newer engine with not too many hours on it, so in good shape as the majority of the "Great Loop" will be motored.
Dean purchased wood to make the shorter mast to carry the radar, radio antenna and fore deck lights, since we will be leaving the main and mizzen at home.
Looks like we may either use our 1980's "antique" radar and monitor or purchase a newer unit.
Because our boat is a Coaster 33 English North Seas boat circa 1982, many of the electronics and other parts are original, most in good shape, but old. It is very hard to find replacement parts for older equipment.
The toilet is a Baby Blake from England and you can only buy parts from their supplier in England or one in Florida. A complete repair kit costs as much as many newer toilets.The toilet(head) works fine, a little hard to pump due to stiff gaskets and a build up of salts.
The carpet on the floors, yes, carpet,
plywood underneath, can be replaced by newer and lighter color, ours is dark brown.  The new carpet will come in 6' or 8 ' X 12ft piece. We then have to take the old out. Fortunately, it is not glued down, as there are compartments under that we need access to, to cut the new to fit. Not too bad a job.
I need to measure the porthole windows to make screens  so we don't get no-see-ums and mosquitoes inside. Why weren't these windows made with screens?  We also want to put a hatch in the back berth for ventilation. The existing vent there now does not facilitate much air movement so very warm and perhaps humid to sleep in.
I am looking at new foam 2-3 " thick for a cushion to put on top of what is there for more comfort. And nautical fabric, that will go with Hunter Green cushions and curtains. Any suggestions? Most of the greens are spring green or off green that does not go well with our green. Also new dishes, I had purchased some melamine dishes at a store and through research found there is dishware designed for marine craft with non slip bottoms and smaller mugs to fit in the attached racks.